1/10/2023 0 Comments Battery jump starter![]() In the meantime, if possible, drive the vehicle normally (not heavy traffic) for around 30 mins to try to put some charge back into the battery. The vehicles’ battery will need to recharge fully for it to be fully serviceable, which is best achieved using a quality battery charger for several hours. Switch off the engine, then switch off the battery pack and remove the leads from the battery pack. If the vehicle does start, keep the engine running for about 5 minutes. In this event, seek professional help by calling the RAC on 03. If it doesn’t start after a few attempts, it might be more serious than a flat battery. Once the battery pack is connected, switch on the pack and attempt to start the vehicle as you normally would. Avoid placing it on the engine as it might fall off when the engine starts. Stand the battery pack on the ground next to the vehicle, the leads are usually long enough to reach the battery. Connect the negative (black) lead to a good earth point on the casualty vehicle – a solid metal part of the engine is usually best. It’ll probably be hidden under a plastic cover – unclip this and you should see the battery with its two terminals.Ĭonnect the positive (red) lead from the battery pack to the positive (+) terminal of the battery. Locate the vehicle battery - usually situated in the engine bay under the bonnet, but in some vehicles, it is located in the boot. Jump starting with a portable battery packįirst check that the battery pack is fully charged. Remove any rings or metal jewellery you’re wearing and make sure nothing metal touches the terminals on the battery.Check for damage - if there’s any obvious damage to either of the batteries, or the jump leads, don’t risk attempting a jump start.Consult your owners manual first and If you’re not confident that you know what you’re doing, give the RAC a call on 03 and we’ll be happy to help. When jump starting a vehicle, it’s important not to take risks. These can be purchased from the RAC shop and are able to jump start a car without the use of another vehicle. If you're worried about getting stranded with a flat battery when you are unable to call for help or seek assistance from someone, then you can buy a portable battery pack as a precaution, to keep you mobile if your battery goes flat. Car battery conditioners and trickle chargers – everything you need to know.10 checks to prevent a winter breakdown. ![]() In the meantime, if possible, drive the vehicle normally (not in heavy traffic) for around 30 mins to try to put some charge back into the battery. The battery will need to recharge fully for it to be fully serviceable, which is best achieved using a quality battery charger for several hours. Restart the engine on the casualty vehicle. Disconnect the other end of the red jump lead from the battery on the casualty vehicle.Disconnect the red jump lead that is connected to the second vehicle.Disconnect the other end of the black jump lead from the second vehicle.Disconnect the black jump lead that is connected to the casualty vehicle.Switch off the engines on both vehicles.Disconnect the remaining jump leads.Īttach the other end of the black jump lead to a good earth point on the casualty vehicle – a solid metal part of the engine is usually best Switch off the casualty vehicle, disconnect the negative jump lead then check the engine starts again okay.If it does start, leave it running for about five minutes.Now attempt to start the casualty vehicle.Then attach the other end of the black jump lead to a good earth point on the casualty vehicle – a solid metal part of the engine is usually best.Attach one end of the black jump lead to the negative terminal of the good battery.Then attach the other end of the red jump lead to the positive terminal of the good battery on the second vehicle.Pull the cover back to access the terminal. The positive terminal will usually have a red plastic cover with a plus (+) symbol on it. Attach one end of the red jump lead to the positive terminal on the flat battery.Ensure both vehicles engines are switched off, remove the ignition keys and open their bonnets (or boot if the battery’s located there).Park the second vehicle as close to the casualty vehicle as possible, without the vehicles touching, ensuring the jump leads will comfortably reach from one battery to the other.Before starting, make sure any electrical systems or devices in the vehicle with the dead battery are switched off (Lights, radio/CD, sat-nav etc) and if possible, lower the drivers window.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |